TRS
option of leaving the negative input open or grounded. We recommend
grounding the unused negative input, which can be done by wiring the ring
and sleeve of the TRS plug together.
For balanced wiring, a three-conductor TRS plug is necessary.
The input wiring of the TRS input connector is as follows:
<+
<�
<Shield
Note: Input from the TRS and RCA connectors is summed together,
allowing both inputs to be used simultaneously.
3. MID-BOOST SELECTOR SWITCH: This 2-position switch selects the Mid-Boost
mode setting. The OOut� position setting produces a flat frequency response curve,
while the OIn� position provides an added boost in the mid-range frequencies.
4. SPEAKER TERMINALS: The rear panel of both Left and Right Speaker enclosures
contains a spring-action speaker terminal. The included speaker wire should be
used to connect the terminal on the left speaker to the terminal on the right speaker.
5. POWER RECEPTACLE: Accepts a detachable 2-circuit line cord in order to
power the DX4 system.
6. PRODUCT LABEL: Contains your DX4Os model and serial number information.
7. POWER SWITCH: This switch turns the DX4 system on and off. The On position
is indicated by the white dot on the switch.
8. SUB FREQUENCY PORT: This port aids in the reproduction of very low
frequencies by discharging the frequencies below 60Hz.
Installation
In order to ensure optimal performance your DX4 system, please read carefully the
following instructions before beginning installation.
Precautions
Handling: The DX4 speakers are packaged tightly within the box, so your attention is
required when removing them. To avoid possible damage to the speaker, hold both
not the front or the back
cones (the Woofer and the Tweeter) should not be touched in order to avoid damage
even after they are removed from the box. Please do not touch the speaker cones (the
Woofer or the Tweeter).
5 |